Surfaces must be smooth, dry, clean & firm. The product may not adhere to unclean/textured surfaces. Allow at least 4 weeks for newly painted surfaces to fully cure (or longer, if recommended by paint manufacturer). Test product in an inconspicuous location of surface before applying to desired location.

• Tape Measure
• Level (or Plumb Bob) & Pencil
• Ruler or Straight Edge
• Utility Knife & Plastic Smoother Set
• Step Stool or Step Ladder

1. Let the product acclimate/acclimatize in the room it will be applied, for a minimum of 48 hours.
2. Clean surface using warm water only. If chemical cleaners, or soap is used, there can be no residue.
3. Allow at least 4 weeks for newly painted surfaces to fully cure (or longer, if recommended by paint manufacturer)
4. Test product in an inconspicuous location of surface before applying to desired location.

Surfaces must be smooth, dry, clean & firm. The product may not adhere to unclean/textured surfaces.

Use your countertop as a leveled guide for an even application. Or Use a level to draw a horizontal line as a guide during application.

*Do not stretch the material. This can cause gaps between the seams overtime.

Fold 12 inches down of protective backing, (avoid touching adhesive - dust, dirt and oils will affect its strength) and press lightly to align to your guide. Remove more backing and press firmly when satisfied with placement. Do not stretch the material. If there are seams, this may cause gaps overtime. If hanging multiple strips, it is recommended to slightly overlap strips by 1/32in (.5mm). Remove the sheet to reposition if needed.

Use a plastic smoother to adhere product to wall. Trim product using a straight edge & sharp utility knife or scissors. Using the smoother to ensure adhesion is important.

Slowly pull edge from top corner directly downward. This product’s adhesive is repositionable & always removable.

Surfaces must be smooth, dry, clean & firm. The product may not adhere to unclean/textured surfaces. Allow at least 4 weeks for newly painted surfaces to fully cure (or longer, if recommended by paint manufacturer). Test product in an inconspicuous location of surface before applying to desired location.

• Check all batch & pattern numbers match.
• Check all tiles are undamaged & free from misprints.
• Check you have sufficient packs to complete the job, allowing for design repeat.

• Tape Measure
• Level (or Plumb Bob) & Pencil
• Ruler or Straight Edge
• Utility Knife & Plastic Smoother Set
• Step Stool or Step Ladder

• Let the product acclimate/acclimatize in the room it will be applied, for a minimum of 48 hours.
• Clean surface using warm water only. If chemical cleaners, or soap is used, there can be no residue.
• Allow at least 4 weeks for newly painted surfaces to fully cure (or longer, if recommended by paint manufacturer)
• Test product in an inconspicuous location of surface before applying to desired location.

Surfaces must be smooth, dry, clean & firm. The product may not adhere to unclean/textured surfaces.

Use your countertop as a leveled guide for an even application. Or Use a level to draw a horizontal line as a guide during application.

*Do not stretch the material. This can cause gaps between the seams overtime.

Fold down protective backing, (avoid touching adhesive - dust, dirt and oils will affect its strength) and press lightly to align first tile to your guide. Remove backing, pressing firmly when satisfied with placement.

For remaining tiles, evenly overlap grout lines for a seamless look!

The tiles can be removed by pulling the edge from top corner directly downward, however they are meant to be a more permanent design solution in order to hold up the rigors of a busy home. This means their adhesive is stronger than our decals and NuWallpaper, and so could potentially take a bit of paint off a wall when removed.